307 is a solvent-based, water displacing rust preventive that will dry quickly
to leave a very light oily film. It
is an excellent preservative for between operations and indoor storage of metal
parts. DURACOTE 307 is amber in
color, but upon evaporation, the resulting protective film is colorless. DURACOTE 307 may be used to protect both ferrous and non-ferrous metals without
|Viscosity, SUS @ 100F
||2500 sq./ft.per Gallon
Method; MIL-C-16173E Grade
||30 day min
||6 - 8 months
After wet tumbling operations
After cleaning in alkaline or acidic cleaners
As rust preventive dip on parts after black oxide or phosphate
For temporary indoor protection for parts between machining
or grinding operations
307 is formulated to be used as supplied.
Thinning will affect film build, dry time and product performance. The
maximum performance of this product can be achieved only when the metal
surfaces are clean, and are free of rust and mil scale.
recommends that the ambient and product temperature be 40 - 95 degreesF at the
time of application. Apply by
conventional dip, spray or brush. In
dip operations, displaced water will collect in the bottom of the tank and
should be drained and discarded periodically to assure proper performance.
Take great caution with spray applications. DURACOTE 307 is solvent based and could ignite if aspirated
in the presence of a source of ignition. Never
apply heat or fire as explosion may result.
Please read and understand Material Safety Data Sheet before the
handling or use of this product.
material is regulated may be banned in California’s South Coast Air Quality
Management District (AQMD)per rule 1144 as it exhibits a flash point below 200F
and may have a VOC greater than 300mg/l. This product should not be offered,
sold, shipped to, or used within the AQMD.
be easily removed with mineral spirits or similar petroleum solvent, vapor
degreasing, low pressure steam, or hot alkaline wash such as Maxim's DURACLEAN
215 alkaline cleaner.
.-DURACOTE 307 cures by solvent evaporation
as it is a combustible liquid in its solvented form.
Keep away from excessive heat, open flames and sparks. Use only with
adequate ventilation. Adequate
ventilation is required for proper cure and to ensure against formation of an
explosive atmosphere. The partially cured film should not be exposed to
ignition sources such as flares, flames, sparks, excessive heat or torches.
Refer to MSDS for additional handling and first aid information.
Read and understand Msds before using or disposing of this product.
with soap and water
||Flush with water for 15 minutes
||Do not induce vomiting
Physician if symptoms persist.